Version 7.2 91 Mediant 1000B Gateway & E-SBC
User's Manual 7. CLI-Based Management
To configure the number of displayed output lines by dragging terminal
window:
1. Establish a CLI session with the device.
2. Access the System menu:
# configure system
3. At the prompt, type the following command:
(config-system)# cli-terminal
4. At the prompt, type the following command:
<cli-terminal># window-height automatic
When this mode is configured, each time you change the height of the terminal window
using your mouse (i.e., dragging one of the window's borders or corners), the number of
displayed output command lines is changed accordingly.
To Next Page
Loading...
