CHAPTER72 Configuration Parameters Reference
Mediant 800 Gateway & E-SBC | User's Manual
Parameter Description
'User Inactivity Timer'
[UserInactivityTimer]
Defines the duration (in days) for which a user has
not logged in to the Web interface, after which the
status of the user becomes inactive and can no
longer access the Web interface. These users can
only log in to the Web interface if their status is
changed (to New or Valid) by a Security
Administrator or Master user.
The valid value is 0 to 10000, where 0 means
inactive. The default is 90.
Note: The parameter is applicable only when using
the Local Users table.
'Session Timeout'
[WebSessionTimeout]
Defines the duration (in minutes) of inactivity of a
logged-in user in the Web interface, after which the
user is automatically logged off the Web session. In
other words, the session expires when the user has
not performed any operations (activities) in the Web
interface for the configured duration.
The valid value is 0, or 2 to 100000, where 0 means
no timeout. The default is 15.
Note: You can also configure the feature per user in
the Local Users table (see Configuring Management
User Accounts), which overrides this global setting.
'Deny Access On Fail Count'
[DenyAccessOnFailCount]
Defines the maximum number of failed login
attempts, after which the requesting IP address is
blocked.
The valid value range is 0 to 10. The values 0 and 1
mean immediate block. The default is 3.
'Deny Authentication Timer'
[DenyAuthenticationTimer]
Defines the duration (in seconds) for which login to
the Web interface is denied from a specific IP
address (for all users) when the number of failed
login attempts has exceeded the maximum. This
maximum is defined by the
DenyAccessOnFailCount parameter. Only after this
time expires can users attempt to login from this
same IP address.
The valid value is 0 to 100000, where 0 means that
login is not denied regardless of number of failed
login attempts. The default is 60.
'Display Last Login Information'
[DisplayLoginInformation]
Enables the display of the user's login information
on each successful login attempt.
■ [0] Disable (default)
■ [1] Enable
[EnableMgmtTwoFactorAuthentication] Enables Web login authentication using a third-
party, smart card.
■ [0] = Disable (default)
■ [1] = Enable
- 1155 -
To Next Page
Loading...
