AudioCodes Mediant 800 - Page 1196

CHAPTER72 Configuration Parameters Reference
Mediant 800 Gateway & E-SBC | User's Manual
Parameter Description
When enabled, the device retrieves the Web user’s
login username from the smart card, which is
automatically displayed (read-only) in the Web
Login screen; the user is then required to provide
only the login password.
Typically, a TLS connection is established between
the smart card and the device’s Web interface, and
a RADIUS server is implemented to authenticate
the password with the username. Thus, this feature
implements a two-factor authentication - what the
user has (the physical card) and what the user
knows (i.e., the login password).
[CSRFProtection] Enables cross-site request forgery (CSRF)
protection of the device's embedded Web server.
■ [0] = Disable
■ [1] = (Default) Enable
For more information, see Configuring CSRF
Protection on page54.
http-port
[HTTPport]
Defines the LAN HTTP port for Web management.
To enable Web management from the LAN,
configure the desired port.
The default is 80.
Note: For the parameter to take effect, a device
reset is required.
[DisableWebConfig] Determines whether the entire Web interface is
read-only.
■ [0] = (Default) Enables modifications of
parameters.
■ [1] = Web interface is read-only.
When in read-only mode, parameters can't be
modified and the following pages can't be
accessed: Web User Accounts, TLS Contexts,
Time and Date, Maintenance Actions, Load
Auxiliary Files, Software Upgrade Wizard, and
Configuration File.
Note:
■ For the parameter to take effect, a device reset
is required.
[ResetWebPassword] Enables the device to restore the default
management users:
■ Security Administrator user (username "Admin";
password "Admin")
■ Monitor user (username "User"; password
"User")
In addition, all other users that may have been
configured (in the Local Users table) are deleted.
- 1156 -