AudioCodes Mediant 800 - Page 1205

CHAPTER72 Configuration Parameters Reference
Mediant 800 Gateway & E-SBC | User's Manual
Parameter Description
The valid value is 0 to 180,000. The default
is 0, meaning that this alarm is not sent
when the phone goes off-hook.
Note:
■ The parameter is applicable only to FXS
interfaces.
■ The parameter's setting is applied only
to phones that go off-hook after you have
configured the parameter.
configure system > snmp settings
> engine-id
[SNMPEngineIDString]
Defines the SNMP engine ID for
SNMPv2/SNMPv3 agents. This is used for
authenticating a user attempting to access
the SNMP agent on the device.
The ID can be a string of up to 36
characters. The default is
00:00:00:00:00:00:00:00:00:00:00:00 (12
Hex octets characters). The provided key
must be set with 12 Hex values delimited by
a colon (":") in the format xx:xx:...:xx. For
example,
00:11:22:33:44:55:66:77:88:99:aa:bb
Note:
■ For the parameter to take effect, a
device reset is required.
■ Before setting the parameter, all
SNMPv3 users must be deleted;
otherwise, the parameter setting is
ignored.
■ If the supplied key does not pass
validation of the 12 Hex values input or it
is set with the default value, the engine
ID is generated according to RFC 3411.
■ When the device operates in HA mode,
the parameter has the same value for
both active and redundant devices (i.e.,
system identifier). If the two devices
return to Standalone mode (i.e., non-HA
mode), you must configure the
parameter to a NULL value (i.e., no
value) for both devices. When the
devices reset to the Standalone mode,
each device automatically sets the
parameter to a unique value based on its'
serial number (S/N).
SNMP Trap Destination Parameters
(configure system > snmp trap destination)
Note: Up to five SNMP trap managers can be defined.
- 1165 -