AudioCodes Mediant 800 - Page 1213

CHAPTER72 Configuration Parameters Reference
Mediant 800 Gateway & E-SBC | User's Manual
Parameter Description
[ResetNow] Invokes an immediate device reset. This option can be used
to activate offline (i.e., not on-the-fly) parameters that are
loaded using the parameter IniFileUrl.
■ [0] = (Default) The immediate restart mechanism is
disabled.
■ [1] = The device immediately resets after an ini file with
the parameter set to 1 is loaded.
Note: If you use the parameter in an ini file for periodic
automatic provisioning with non-HTTP (e.g., TFTP) and
without CRC, the device resets upon every file download.
Software and Configuration File URL Path for Automatic Update Parameters
configure system > automatic-update >
firmware
[CmpFileURL]
Defines the name of the cmp file and the URL address (IP
address or FQDN) of the server where the file is located.
Optionally, the username and password (username:password)
for access authentication with the server can also be
configured. For example:
'http://192.168.0.1/filename'
'https://<username>:<password>@<IP address>/<file
name>'
Note:
■ For the parameter to take effect, a device reset is required.
■ When the parameter is configured, the device always
loads the cmp file after it is reset.
■ The cmp file is validated before it's burned to flash. The
checksum of the cmp file is also compared to the
previously burnt checksum to avoid unnecessary resets.
■ The maximum length of the URL address is 255
characters.
voice-configuration
[IniFileURL]
Defines the name of the ini file and the URL address (IP
address or FQDN) of the server where the file is located.
Optionally, the username and password
('https://username:password@10.1.1.1/<file name>') for
access authentication with the server can also be configured.
For example:
'http://192.168.0.1/filename'
'http://192.8.77.13/config_<MAC>.ini'
'https://<username>:<password>@<IP
address>/<filename>'
Note:
■ For the parameter to take effect, a device reset is required.
- 1173 -