CHAPTER13 Network
Mediant 800 Gateway & E-SBC | User's Manual
Parameter Description
■ The parameter value cannot contain a forward slash
(/).
'Application Type'
application-type
[InterfaceTable_
ApplicationTypes]
Defines the applications allowed on the IP interface.
■ [0] OAMP = Operations, Administration, Maintenance
and Provisioning (OAMP) applications (e.g., Web,
Telnet, SSH, and SNMP).
■ [1] Media = Media (i.e., RTP streams of voice).
■ [2] Control = Call Control applications (e.g., SIP).
■ [3] OAMP + Media = OAMP and Media applications.
■ [4] OAMP + Control = OAMP and Call Control
applications.
■ [5] Media + Control = Media and Call Control
applications.
■ [6] OAMP + Media + Control = All application types
are allowed on the interface.
■ [99] MAINTENANCE = Only the Maintenance
application for HA is allowed on this interface.
Note:
■ Only one IP network interface can be configured with
OAMP in this table. To configure additional
management interfaces, see Configuring Additional
Management Interfaces.
'Ethernet Device'
underlying-dev
[InterfaceTable_
UnderlyingDevice]
Assigns an Ethernet Device to the IP interface. An
Ethernet Device is a VLAN associated with a physical
Ethernet port (Ethernet Group). To configure Ethernet
Devices, see Configuring Underlying Ethernet Devices.
By default, no value is defined.
Note: The parameter is mandatory.
IP Address
'Interface Mode'
mode
[InterfaceTable_InterfaceMode]
Defines the method that the interface uses to acquire its
IP address.
■ [3] IPv6 Manual Prefix = IPv6 manual prefix IP
address assignment. The IPv6 prefix (higher 64 bits)
is set manually while the interface ID (the lower 64
bits) is derived from the device's MAC address.
■ [4] IPv6 Manual = IPv6 manual IP address (128 bits)
assignment.
■ [10] IPv4 Manual = (Default) IPv4 manual IP address
(32 bits) assignment.
'IP Address'
ip-address
[InterfaceTable_IPAddress]
Defines the IPv4/IPv6 address in dotted-decimal
notation.
By default, no value is defined.
Note: The parameter is mandatory.
- 100 -