AudioCodes Mediant 800 - Page 142

CHAPTER13 Network
Mediant 800 Gateway & E-SBC | User's Manual
■ Single IP network interface for all applications:
The IP Interfaces table is configured with a single interface for OAMP, Media and Control:
Inde-
x
Name
Applic-
ation Type
Eth-
ernet
Device
Inter-
face
Mode
IP
Address
Prefix
Lengt-
h
Default
Gateway
0 myInterfac
e
OAMP +
Media +
Control
1 IPv4
Manual
192.168.0.
2
16 192.168.0.
1
Two routes are configured in the Static Routes table for directing traffic for subnet
201.201.0.0/16 to 192.168.11.10, and all traffic for subnet 202.202.0.0/16 to 192.168.11.1:
Index Destination Prefix Length Gateway
0 201.201.0.0 16 192.168.11.10
1 202.202.0.0 16 192.168.11.1
The NTP applications remain with their default application types.
■ Multiple interfaces, one per application type:
The IP Interfaces table is configured with three interfaces, each for a different application type
(one for OAMP, one for Call Control, and one for RTP Media), and each with a different VLAN
ID and default gateway:
Inde-
x
Name
Applic-
ation
Type
Eth-
ernet
Device
Inter-
face
Mode
IP Address
Prefix
Lengt-
h
Default
Gateway
0 Management
IF
OAMP 1 IPv4
Manual
192.168.0.2 16 192.168.0.
1
1 myControlIF Control 200 IPv4
Manual
200.200.85.
14
24 200.200.85
.1
2 myMediaIF Media 211 IPv4
Manual
211.211.85.
14
24 211.211.85
.1
A routing rule in the Static Routes table is required to allow remote management from a host in
176.85.49.0/24:
Index Destination Prefix Length Gateway
0 176.85.49.0 24 192.168.11.1
All other parameters are set to their respective default values. The NTP application remains
with its default application types.
■ Multiple interfaces with combined application types:
● A single interface for OAMP.
● Interfaces for Call Control and Media applications, where two of them are IPv4 interfaces
and one is an IPv6 interface.
The IP Interfaces table is configured as follows:
- 102 -