AudioCodes Mediant 800 - Page 250

CHAPTER16 Services
Mediant 800 Gateway & E-SBC | User's Manual
Parameter Description
The default value is the asterisk (*) symbol, meaning any
source number or URI.
'Recorded Destination Pattern'
recorded-dst-prefi
[SIPRecRouting_
RecordedDestinationPrefix]
Defines calls to record based on destination number or URI.
You can use special patterns (notations) to denote the
number or URI. For example, if you want to match this rule
to user parts whose last four digits (i.e., suffix) are 4 followed
by any three digits (e.g., 4008), then configure this parameter
to "(4xxx)". For available patterns, see Patterns for Denoting
Phone Numbers and SIP URIs on page1148.
The default value is the asterisk (*) symbol, meaning any
destination number or URI.
'Condition'
condition-name
[SIPRecRouting_
ConditionName]
Assigns a Message Condition rule to the SIP Recording rule
to base the start of call recording on a specific condition. To
configure Message Condition rules, see Configuring
Message Condition Rules on page536.
For more information on using conditions with SIPRec, see
Using Conditions for Starting a SIPRec Session on the next
page.
'Peer IP Group'
peer-ip-group-name
[SIPRecRouting_
PeerIPGroupName]
Defines the peer IP Group that is participating in the call.
By default, all IP Groups are defined (Any).
'Peer Trunk Group ID'
peer-trunk-group-id
[SIPRecRouting_
PeerTrunkGroupID]
Defines the peer Trunk Group that is participating in the call.
To configure Trunk Groups, see Configuring Trunk Groups.
Note: The parameter is applicable only to the Gateway
application.
'Caller'
caller
[SIPRecRouting_Caller]
Defines which calls to record according to which party is the
caller.
■ [0] Both = (Default) Caller can be peer or recorded side
■ [1] Recorded Party (in Gateway, IP-to-Tel call)
■ [2] Peer Party (in Gateway, Tel-to-IP call)
Recording Server
'Recording Server (SRS) IP
Group'
srs-ip-group-name
[SIPRecRouting_
SRSIPGroupName]
Defines the IP Group of the recording server (SRS).
By default, no value is defined.
Note:
■ The parameter is mandatory.
■ The SIP Interface used for communicating with the SRS
is according to the SRD assigned to the SRS IP Group
(in the IP Groups table). If two SIP Interfaces are
associated with the SRD - one for "SBC" and one for
"GW" – the device uses the "SBC" SIP Interface. If no
SBC SIP Interface type is configured, the device uses
the “GW” interface (which means that SRS redundancy
cannot be supported).
- 210 -