AudioCodes Mediant 800 - Page 414

CHAPTER18 Core Entities
Mediant 800 Gateway & E-SBC | User's Manual
Parameter Description
■ [0] No = (Default) The device creates a new Call-ID
value for the outgoing message.
■ [1] Yes = The device uses the same Call-ID value
received in the incoming message for the Call-ID in
the outgoing message.
Note: When the device sends an INVITE as a result of a
REFER/3xx termination, the device always creates a
new Call-ID value and ignores the parameter's settings.
'Dial Plan'
sbc-dial-plan-name
[IPGroup_SBCDialPlanName]
Assigns a Dial Plan to the IP Group. The device
searches the Dial Plan for a dial plan rule that matches
the prefix of the source number and if not found, for a rule
that matches the prefix of the destination number. If a
matching dial plan rule is found, the rule's tag is used in
the routing and/or manipulation processes as source
and/or destination tags.
To configure Dial Plans, see Configuring Dial Plans.
Note: For IP-to-IP Routing rules that are configured for
destination based on tags (i.e., 'Destination Type'
parameter configured to Destination Tag), the parameter
is applicable only to the source IP Group and the device
searches the Dial Plan for a dial plan rule that matches
the prefix of the destination number only. For more
information on routing based on destination tags, see
Using Dial Plan Tags for Routing Destinations.
'Tags'
tags
[IPGroup_Tags]
Defines a tag, which can be implemented in one of the
following manners:
■ Classification based on source tags: If the tag
(name=value or value only) is the same tag as that of
the incoming SIP dialog (obtained from the Call
Setup Rule associated with the SIP Interface on
which the dialog is received) and configured in the
Classification table, then the incoming dialog is
classified to this IP Group. For more information, see
Configuring Classification Based on Tags on
page792.
■ Routing based on destination tags: Assigns a
Dial Plan tag which determines whether the
incoming SIP dialog is sent to this IP Group. The
parameter is used when IP-to-IP Routing rules are
configured for destinations-based on tags (i.e.,
'Destination Type' parameter configured to
Destination Tag). For more information, see Using
Dial Plan Tags for Routing Destinations.
- 374 -