AudioCodes Mediant 800 - Page 415

CHAPTER18 Core Entities
Mediant 800 Gateway & E-SBC | User's Manual
Parameter Description
The valid value is a string of up to 70 characters. You
can configure the parameter with up to five tags, where
each tag is separated by a semicolon (;). Each tag can
have a name and value (e.g., Country=Ireland) or only a
value (e.g., Ireland). You can also configure multiple
tags with the same name (e.g.,
Country=Ireland;Country=Scotland).
Note: For tag-based classification, if multiple IP Groups
are configured with the same tag, the device classifies
the incoming SIP dialog to the first matching IP Group.
'Call Setup Rules Set ID'
call-setup-rules-set-id
[IPGroup_CallSetupRulesSetId]
Assigns a Call Setup Rule Set ID to the IP Group. The
device runs the Call Setup rule immediately before the
routing stage (i.e., only after the classification and
manipulation stages).
By default, no value is assigned.
To configure Call Setup Rules, see Configuring Call
Setup Rules.
Quality of Experience
'QoE Profile'
qoe-profile
[IPGroup_QOEProfile]
Assigns a Quality of Experience Profile rule.
By default, no value is defined.
To configure Quality of Experience Profiles, see
Configuring Quality of Experience Profiles.
'Bandwidth Profile'
bandwidth-profile
[IPGroup_BWProfile]
Assigns a Bandwidth Profile rule.
By default, no value is defined.
To configure Bandwidth Profiles, see Configuring
Bandwidth Profiles.
Message Manipulation
'Inbound Message Manipulation
Set'
inbound-mesg-
manipulation-set
[IPGroup_InboundManSet]
Assigns a Message Manipulation Set (rule) to the IP
Group for SIP message manipulation on the inbound leg.
By default, no value is defined.
To configure Message Manipulation rules, see
Configuring SIP Message Manipulation.
Note:
■ The parameter is applicable only to the SBC
application.
- 375 -