CHAPTER18 Core Entities
Mediant 800 Gateway & E-SBC | User's Manual
Parameter Description
■ The IPGroup_SIPGroupName parameter overrides
inbound message manipulation rules (assigned to
the IPGroup_InboundManSet parameter) that
manipulate the host name in Request-URI, To,
and/or From SIP headers. If you want to manipulate
the host name using message manipulation rules in
any of these SIP headers, you must apply your
manipulation rule (Manipulation Set ID) to the IP
Group as an Outbound Message Manipulation Set
(see the IPGroup_OutboundManSet parameter),
when the IP Group is the destination of the call.
'Outbound Message Manipulation
Set'
outbound-mesg-
manipulation-set
[IPGroup_OutboundManSet]
Assigns a Message Manipulation Set (rule) to the IP
Group for SIP message manipulation on the outbound
leg.
By default, no value is defined.
To configure Message Manipulation rules, see
Configuring SIP Message Manipulation.
Note: If you assign a Message Manipulation Set ID that
includes rules for manipulating the host name in the
Request-URI, To, and/or From SIP headers, the
parameter overrides the IPGroup_SIPGroupName
parameter.
'Message Manipulation User-
Defined String 1'
msg-man-user-defined-
string1
[IPGroup_MsgManUserDef1]
Defines a value for the SIP user part that can be used in
Message Manipulation rules configured in the Message
Manipulations table. The Message Manipulation rule
obtains this value from the IP Group, by using the
following syntax:
param.ipg.<src|dst>.user-defined.<0>.
The valid value is a string of up to 30 characters. By
default, no value is defined.
To configure Message Manipulation rules, see
Configuring SIP Message Manipulation.
'Message Manipulation User-
Defined String 2'
msg-man-user-defined-
string2
[IPGroup_MsgManUserDef2]
Defines a value for the SIP user part that can be used in
Message Manipulation rules configured in the Message
Manipulations table. The Message Manipulation rule
obtains this value from the IP Group, by using the
following syntax: param.ipg.<src|dst>.user-defined.<1>.
The valid value is a string of up to 30 characters. By
default, no value is defined.
To configure Message Manipulation rules, see
Configuring SIP Message Manipulation.
'Proxy Keep-Alive using IP Group
Settings'
proxy-keepalive-use-ipg
[ProxyKeepAliveUsingIPG]
Enables the device to apply certain IP Group settings to
keep-alive SIP OPTIONS messages that are sent by the
device to the proxy server. The parameter is applicable
only if you have enabled proxy keep-alive for the Proxy
Set that is associated with the IP Group (see
Configuring Proxy Sets on page384).
- 376 -
To Next Page
Loading...
