AudioCodes Mediant 800 - Page 953

CHAPTER45 Upgrading the Device's Software
Mediant 800 Gateway & E-SBC | User's Manual
When the file is loaded, a message is displayed to inform you that the file was successfully
loaded.
8. If your device is in HA mode, select one of the following upgrade options:
● Hitless Upgrade (default)
● System Reset Upgrade
See the description of these methods in the beginning of this section.
If you select the Hitless Upgrade option, the wizard can only be used to upload a .cmp
file; Auxiliary and ini files cannot be uploaded.
9. To load additional files, use the Next and Back buttons to navigate through the wizard to the
desired file-load wizard page; otherwise, skip to the next step to load the .cmp file only.
The wizard page for loading an ini file lets you do one of the following:
● Load a new ini file:
i. Click Browse, and then navigate to and select the new ini file.
ii. Click Load File; the device loads the ini file.
● Restore configuration to factory defaults: Clear the 'Use existing configuration' check
box.
● Retain the existing configuration (default): Select the 'Use existing configuration'
check box.
- 913 -