Page 4–92
DURApulse GS4 AC Drive User Manual – 1st Ed, Rev A - 10/20/2017
Chapter 4: AC Drive Parameters
Type Hex Addr Dec Addr
P3.58 Local/Remote Switch Mode
R/W 033A 40827
Range/Units (Format: 16-bit binary) Default
0: Used for HAND/OFF/AUTO control from external terminals if MFI settings 31 and
32 are configured� If no multi-function inputs are configured for 31 or 32, then
only HAND/AUTO control will be available by using the keypad LOCAL (HAND) and
REMOTE (AUTO)� The OFF feature of HOA will not be available� MFI setting 33 will
not be valid when P3�58= 0�
1: Always Stop When Switching: If the drive is running when switching from Local
to Remote or Remote to Local, the drive will stop when switched unless there is
an active RUN command applied to the switched-to mode� If the drive is already
stopped, it still remains stopped�
2: Follow Remote Mode: The drive still follows the setting at Remote while switching
to Local� For example, if the setting at Remote is "running," the drive keeps on
"running" even after the drive is switched from Remote to Local� Unless a "stop"
command is given, then the drive will be stopped under Local mode�
3: Follow Local Mode: The drive still follows the setting at Local while switching to
Remote� For example, if the setting at Local is “stop,” the drive keeps “stopping”
even after the drive is switched to Remote mode� Unless a “running” command
is present or given in Remote mode, then the drive will start to run under Remote
mode�
4: Follow Local and Remote Mode: The drive follows the settings of both Local
and Remote� When switching from one mode to another, the drive follows the
command of the previous mode unless a new command is given on the switched-to
mode�
4
Source of operation must be defined in P3.00, P3.01, P4.00, and P4.01.
Settings 0~4:
When set to 0, upper right corner of screen will display “HAND” or “AUTO”. When set to 1, 2, 3, or 4,
the upper right corner of the screen will display “LOC” or “REM.”
If P3.58 ≠ 0 and a multi-function input is set to 31 or 32, then HOA control has priority and
the upper right corner of the screen will display “HAND” or “AUTO.”
To Next Page
Loading...
