Chapter 4: AC Drive Parameters
Page 4–211
DURApulse GS4 AC Drive User Manual – 1st Ed, Rev A - 10/20/2017
Type Hex Addr Dec Addr
P11.27 Digital Output Status at Fault
Read 0B1B 42844
Range/Units (Format: 16-bit binary) Default
0~65535
0
P11.27 captures the value of P3.46 Digital Output Status at the instant of last drive fault. If another
fault occurs, the previous record will be overwritten.
Representation of bits:
•
Bit1~Bit0: 00: RUN LED light off; STOP LED light on (Drive Stop)
01: RUN LED blink; STOP LED light on (Drive Decelerating during stopping)
10: RUN LED light on; STOP LED blink (Drive Standby)
11: RUN LED light on; STOP LED light off (Drive Run)
•
Bit2: 1: JOG active
•
Bit4~Bit3: 00: REV LED light off; FWD LED light on (Forward)
01: REV LED blink; FWD LED light on (Reverse to Forward)
10: REV LED light on; FWD LED blink (Forward to Reverse)
11: REV LED light on; FWD LED light off (Reverse)
•
Bit5: 1: Factory parameters group opened state
•
Bit6: 1: Advance parameter group opened state
•
Bit7: 1: Operation command controlled by external terminal
•
Bit8: 1: Main frequency controlled by communication
•
Bit9: 1: Main frequency controlled by external terminal (AI)
•
Bit10: 1: Operation command controlled by communication (PU)
•
Bit11: 1: Parameters have been locked
•
Bit12: 1: Copy command enable
•
Bit15~Bit13: 0: HOA mode OFF
1: HOA mode HAND-ON
2: HOA mode AUTO-ON
3: LOC/REM mode LOC-ON
4: LOC/REM mode REM-ON
Type Hex Addr Dec Addr
P11.28 Drive Status at Fault
Read 0B1C 42845
Range/Units (Format: 16-bit unsigned) Default
0~65535
0
P11.28 shows the Drive Status at the time of last drive fault. If another fault occurs, the previous
record will be overwritten.
To Next Page
Loading...
