Automation Direct DURApulse GS4 - Page 353

Chapter 6: Maintenance and Troubleshooting
Page 6–21
DuRApulse GS4 AC Drive User Manual – 1st Ed, Rev A - 10/20/2017
Fault Name
Fault Code
in Status
Monitor 1
Fault
Descriptions
Corrective Actions
Can be
Bypassed
in Fire
Mode
(Yes / no)
LOCAL
Fault
AUE
Auto Tuning Err
40
Auto tuning error
1) Check cabling between drive and motor
2) Try again�
no
LOCAL
Fault
AFE
PID Fbk Loss
41
PID loss (ACI)
1) Check the wiring of the PID feedback�
2) Check the PID parameters settings�
no
n/a 42~47
reserved n/a n/a
LOCAL
Fault
ACE
Analog Loss Err
48
Analog Signal Loss
Error (4~20mA)
1) Check the 4~20mA signal wiring (AI1 or AI2)�
2) Check if the analog signal is less than 4mA�
NOTE:
P4�63 or P4�64 must be set to 3 to enable the
Analog Loss Fault�
This fault can be temporarily bypassed by
switching Local/Remote Mode�
(The Fault is active only if the drive is actively
looking for the analog signal)�
no
LOCAL
Fault
EF
External Fault
49
External Fault
1) Input EF (N�O�) on external terminal is closed
to GND� Output U, V, W will be turned off�
2) Press Reset after fault has been cleared�
no
LOCAL
Fault
EF1
Emergency Stop
50
Emergency stop
1) When the multi-function input terminals DI1
to DI6 are set to emergency stop, the GS4
drive stops output U, V, W and the motor
coasts to stop�
2 Press RESET after fault has been cleared�
no
LOCAL
Fault
bb
Base Block
51
External Base Block
1) When the external input terminal (B.B) is
acve, the GS4 drive output will be turned
o.
2) Deacvate the external input terminal
(B.B) to operate the GS4 drive again.
no
LOCAL
Fault
Pcod
Password Error
52
Password is locked
Keypad will be locked� Power cycle the drive
then re-enter the correct password� See P8�06
and P8�07�
no
LOCAL
Fault
ccod
SW Code Lock
53
Software version
error
The firmware version is corrupt�
Please re-download the firmware�
no
(continued next page)