Baumer VLXT - Opticcontrollerinitialize; Opticcontrollermodelname (Except.EF); Opticcontrollerselector; Opticcontrollerserialnumber (Except.EF)

174
V2.6 | 8/30/2022 | 1120758
7.17.14 OpticControllerInitialize
Initializes the optic controller and makes it ready for use.
Notice
For lens detection, you must execute this command after connecting the lens. After
detecting a supported lens, the corresponding features are available.
Name OpticControllerInitialize
Category OpticControl
Interface ICommand
Access Write only
Unit -
Values -
7.17.15 OpticControllerModelName (except .EF)
Model name of the optic controller.
Name OpticControllerModelName
Category OpticControl
Interface IString
Access Read only
Unit -
Values e.g. Caspian C-C-39N0-160R33
7.17.16 OpticControllerSelector
Selects which optic controller to congure.
Name OpticControllerSelector
Category OpticControl
Interface IEnumeration
Access Read / Write
Unit -
Values OpticController0 Optic Controller 0.
7.17.17 OpticControllerSerialNumber (except .EF)
Serial number of the optic controller.
Name OpticControllerSerialNumber
Category OpticControl
Interface IString
Access Read only
Unit -
Values e.g. 1731170157