Baumer VLXT - Category: Eventcontrol; Eventnotification; Eventselector

118
V2.6 | 8/30/2022 | 1120758
7.11 Category:EventControl
This chapter describes how to control the generation of Events to the host application. An
Event is a message that is sent to the host application to notify it of the occurrence of an
internal event.
General Information
The asynchronous message channel is described in the GigE Vision
®
standard and of-
fers the possibility of event signaling. There is a timestamp (64 bits) for each announced
event, which contains the accurate time the event occurred.
Each event can be activated and deactivated separately (EventSelector).
7.11.1 EventNotication
Activate or deactivate the notication to the host application of the occurrence of the se-
lected Event.
Name EventNotication
Category EventControl
Interface IEnumeration
Access Read / Write
Unit -
Values
Off The selected Event notication is disabled.
On The selected Event notication is enabled.
7.11.2 EventSelector
Selects which Event to signal to the host application.
Name EventSelector
Category EventControl
Interface IEnumeration
Access Read / Write
Unit -
Values see table below