Baumer VLXT - Balancewhiteautostatus; Brightnessautonominalvalue; Brightnessautopriority

76
V2.6 | 8/30/2022 | 1120758
7.4.8 BalanceWhiteAutoStatus
Status of BalanceWhiteAuto.
Name BalanceWhiteAutoStatus
Category AutoFeatureControl
Interface IEnumeration
Access Read / Write
Unit -
Values
ColorGain-
sTooHigh
The BalanceWhiteAuto calculation failed since at least
one of the calculated color gains exceeds the maximum
value.
Initial BalanceWhiteAuto has never been started.
Start BalanceWhiteAuto is waiting for statistic data.
Success The last BalanceWhiteAuto calculation succeeded.
Underrun
The BalanceWhiteAuto calculation failed since at least
one color-channel shows invalid statistic data.
7.4.9 BrightnessAutoNominalValue
Sets the nominal value for brightness in percent of full scale. It will be adjusted with con-
sider the setting in BrightnessAutoPriority.
Name BrightnessAutoNominalValue
Category AutoFeatureControl
Interface IFloat
Access Read / Write
Unit %
Values 5 - 95 (Increment: 1)
7.4.10 BrightnessAutoPriority
The feature set the highest priority auto feature to adjust the brightness. If both, Expo-
sureAuto and GainAuto, are enabled, this feature determines which one of the control-
parameter ExposureTime or Gain shall be adjusted rst. If the prioritized parameter ex-
ceeds the minimum or maximum limit the second parameter will be adjusted to reach the
target brightness.
Notice
If BrightnessAutoPriority is set to ExposureAuto the image frame rate might be reduced
due to an increased ExposureTime but the image noise will not change..
If BrightnessAutoPriority is set to GainAuto there might occur image noise due to an
increased Gain but the image frame rate remains constant.
Name BrightnessAutoPriority
Category AutoFeatureControl
Interface IEnumeration
Access Read / Write
Unit -
Values
ExposureAuto
ExposureAuto has highest priority and will be modied
rst.
GainAuto GainAuto has highest priority and will be modied rst.