Baumer VLXT - Countervalue; Countervalueatreset; Framecounter

87
V2.6 | 8/30/2022 | 1120758
7.7.8 CounterValue
Reads or writes the current value of the selected Counter. Writing to CounterValue is typi-
cally used to set the start value.
Name CounterValue
Category CounterAndTimerControl
Interface IInteger
Access Read / Write
Unit -
Values 0 ... 65535 (Increment: 1)
7.7.9 CounterValueAtReset
Reads the value of the selected Counter when it was reset by a trigger or by an explicit
CounterReset command.
It represents the last counter value latched before reseting the counter.
Name CounterValueAtReset
Category CounterAndTimerControl
Interface IInteger
Access Read only
Unit -
Values 0 ... 65535 (Increment: 1)
7.7.10 FrameCounter
The FrameCounter is part of the Baumer Image Info Header (chunk) and is added to ev-
ery image if chunk mode is activated. It is generated by the hardware and can be used to
verify that each of the camera's images is transmitted to the PC and received in the right
order.
It is possible to set the FrameCounter to a specic value by write this value to the Frame-
Counter.
Name FrameCounter
Category CounterAndTimerControl
Interface IInteger
Access Read / Write
Unit -
Values 0 ... 4294967295 (Increment: 1)