Baumer VLXT - Triggermode; Triggeroverlap; Triggerselector; Triggersoftware

63
V2.6 | 8/30/2022 | 1120758
7.1.19 TriggerMode
Controls if the selected trigger is active.
Name TriggerMode
Category AcqusitionControl
Interface IEnumeration
Access Read / Write
Unit -
Values
Off Disables the selected trigger.
On Enable the selected trigger.
7.1.20 TriggerOverlap
Species the type trigger overlap permitted with the previous frame.
Name TriggerOverlap
Category AcqusitionControl
Interface IEnumeration
Access Read / Write
Unit -
Values Read Out Trigger is accepted immediately after the exposure period..
7.1.21 TriggerSelector
Selects the type of trigger to congure.
Name TriggerSelector
Category AcqusitionControl
Interface IEnumeration
Access Read / Write
Unit -
Values Frame Start Selects the type of trigger to congure.
7.1.22 TriggerSoftware
Generates a internal trigger. TriggerSource must be set to Software.
Name TriggerSoftware
Category AcqusitionControl
Interface ICommand
Access Write only
Unit -
Values -