Baumer VLXT - Acquisitionframerateenable; Acquisitionmode

56
V2.6 | 8/30/2022 | 1120758
7.1.4 AcquisitionFrameRateEnable
Enables the acquisition at the framerate specied by AcquisitionFrameRate.
Name AcquisitionFrameRateEnable
Category AcquisitionControl
Interface IBoolean
Access Read / Write
Unit -
Values
true = 1 (On)
false = 0 (Off)
7.1.5 AcquisitionMode
Sets the acquisition mode of the device. It denes mainly the number of frames to capture
during an acquisition and the way the acquisition stops.
Notice
The camera must be stopped before this feature can be edited.
Name AcquisitionMode
Category AcqusitionControl
Interface IEnumeration
Access Read / Write
Unit -
Values
Continuous
Frames are captured continuously without external
events until stopped with the AcquisitionStop command.
MultiFrame
In this mode a predened number of frames will be cap-
tured after AcquisitionStart. The AcquisitionFrameCount
controls the number of captured frames. Then the acqui-
sition is automatically stopped.
SingleFrame
In this mode the camera is captured one frame after Ac-
quisitionStart. Then the acquisition is stopped.