Baumer VLXT - Sequencersetstart; Sequencertriggeractivation

182
V2.6 | 8/30/2022 | 1120758
7.18.11 SequencerSetStart
Sets the initial/start sequencer set, which is the rst set used within a sequencer.
Name SequencerSetStart
Category SequencerControl
Interface IInteger
Access Read / Write
Unit -
Values 0 ... 127 (Increment: 1)
7.18.12 SequencerTriggerActivation
Denes the signals edge that triggers the sequencer.
Name SequencerTriggerActivation
Category SequencerControl
Interface IEnumeration
Access Read / Write
Unit -
Values
AnyEdge
Species that the trigger is considered valid on the falling
or rising edge of the source signal.
FallingEdge
Species that the trigger is considered valid on the falling
edge of the source signal.
LevelHigh
(≥ Rel. 2)
Species that the trigger is considered valid as long as
the level of the source signal is high.
LevelLow
(≥ Rel. 2)
Species that the trigger is considered valid as long as
the level of the source signal is low.
RisingEdge
Species that the trigger is considered valid on the rising
edge of the source signal.