95
V2.6 | 8/30/2022 | 1120758
7.9.14 DeviceReset
The Device Reset feature corresponds with the camera's switched on and switched off
states. Using this means it is no longer necessary to disconnect the power supply.
Notice
The execution of this feature may take several seconds.
Name DeviceReset
Category DeviceControl
Interface ICommand
Access Write only
Unit -
Values -
7.9.15 DeviceResetToDeliveryState
By executing this feature, the camera is set to the factory settings. The settings stored in
the camera (e.g. UserSets) will be lost.
Name DeviceResetToDeliveryState
Category DeviceControl
Interface ICommand
Access Write only
Unit -
Values -
7.9.16 DeviceSFNCVersionMajor
Major version of the Standard Features Naming Convention that was used to create the
device`s GenICam XML.
Name DeviceSFNCVersionMajor
Category DeviceControl
Interface IInteger
Access Read only
Unit -
Values 0 ... 9223372036854775807 (Increment: 1)
To Next Page
Loading...
