208 BD FACSAria User’s Guide
5 If the satellites are not merging properly, repeat steps 1 through 3, turning
the cam in the opposite direction.
Turn the cam until the small arrow is approximately 1/4 the distance
between the large arrow and the positive symbol (+1/4 in Figure 6-8).
6 Repeat step 4.
7 If the satellites are still not merging properly, repeat steps 1 through 3,
turning the cam until the small arrow is halfway between the large arrow
and the negative symbol (-1/2 in Figure 6-8). Repeat step 4.
8 If the satellites are still not merging properly, repeat steps 1 through 3,
turning the cam until the small arrow is halfway between the large arrow
and the positive symbol (+1/2 in Figure 6-8). Repeat step 4.
9 If needed, continue adjusting the cam to achieve the required satellite drop
pattern.
NOTE The cam adjustment range extends 180° between the positive and
negative symbols on the adjustable nozzle. If the large arrow points to the
shaded (black) half of the cam, the nozzle adjustment is out of range. For
proper nozzle operation, do not adjust the cam outside its adjustment
range.
10 Turn on the Sweet Spot when the drop pattern is stable.
To Next Page
Loading...
