7-10 BMP
®
61 Label Printer
User’s Manual
Replacing the Printer (Media Well) Cover
Internal Components
Labels (Media)
Printer will not feed labels. The leading edge of the label roll
is not inserted up to the black line
under the ribs.
Make sure the leading edge of the
label roll is securely under the ribs
(at least up to the black line).
Printer will not feed labels. The leading edge of the label roll
is unevent or torn (not a straight
edge).
Use a pair of scissors to cut a
straight leading edge on the label
roll.
Label material jams in printer. Last label was not removed. Make sure the last cut label has
been removed from the label tray.
Error - "Out of Media" Label/Media supply is exhausted
1. Replace label/media roll.
2. Press [CLEAR/ESC] key to
clear error
Error - "Out of Media" Labels/media are not installed
correctly. Labels/media must be
installed so that they are biased
against the front wall of the lower
printer base. Notch Sensors in the
lower printer base need to detect
the prescence of the labels to
allow printer to operate correctly.
1. Reinstall labels/media.
2. Press [CLEAR/ESC] key to
clear error.
(See
page 1-16 for proper
label/media loading.)
Error - "Out of Media" Notch sensors in lower printer
frame are dirty. Notch Sensors in
the lower printer base need to
detect the prescence of the labels
to allow printer to operate
correctly.
1. Clean sensors in lower printer
base. Press [CLEAR/ESC]
key to clear error.
(See
page 7-1 for proper cleaning
techniques.)
Error - "Out of Media" Label/media memory device has
counted down to zero. Circuit
board on the roll holder core of
label/media contains a memory
device that tells the printer how
much unused material remains on
the label/media supply. Reuse of
the roll holder with memory
device will eventually count down
to zero and give error
1. Replace label/media or
label/media roll holder.
2. Press [CLEAR/ESC] key to
clear error.
Problem Cause Corrective Action
To Next Page
Loading...
