Brady BMP 61 - Page 163

BMP
®
61 Label Printer User’s Manual 7-11
Replacing the Printer (Media Well) Cover
Internal Components
Labels (Media) (continued)
Error - "No media installed" BMP71 labels/media are not
installed correctly.
1. Reinstall labels/media.
2. Press [CLEAR/ESC] key to
clear error.
See
page 1-16 for proper
label/media loading. Verify that
circuit board on core of labels are
mating with contacts in receiver
slot of lower printer base.
Error - "No media installed" Damaged circuit board on
label/media roll
1. Replace label/media roll.
2. Press [CLEAR/ESC] key to
clear error
Error - "No media installed" Damaged contacts in receiver slot
of lower printer base.
Send to Brady for Repair
Error - "Top of form" Label/media or ribbon has caused
jam
1. Clear any jams by opening the
printer cover and removing an
excess labels in the feed roller
or exit chute areas.
2. Press [CLEAR/ESC] key to
clear error.
Error - "Top of form" Notch sensors in lower printer
frame are dirty. Notch Sensors in
the lower printer base need to
detect the prescence of the labels
to allow printer to operate
correctly.
1. Clean sensors in lower printer
base.
2. Press [CLEAR/ESC] key to
clear error.
(See
page 7-1 for proper cleaning
techniques.)
Error - "Label and ribbon color
are identical"
Ribbon color and label color are
the same. Printing will not be
visible.
1. Replace ribbon or
label/media.
2. Press [CLEAR/ESC] key to
clear error.
Problem Cause Corrective Action