Brother PE-Design Next - Tutorial 10-2: Creating Design for Multi-Position Hoops

161
Operations for Specific Applications
Tutorial 10-2: Creating Design for Multi-Position Hoops
Tutorial 10-2: Creating Design for Multi-
Position Hoops
This program enables you to create multi-position designs that you can stitch in any multi-position hoop
attached to your embroidery machine.
Although the size of the design that can be embroidered using an multi-position hoop is 130  180 mm (or 100
 100 mm, depending on the sewing area of the embroidery machine), first determine which of the three
installation positions (indicated as a, b, and c in the illustration above) the multi-position hoop will be installed
at and determine the orientation of the design.
When creating the design, each design section can only be as large as the sewing area of the embroidery
machine.
The sample file for this tutorial can be found at the following location.
Documents (My Documents)\PE-DESIGN NEXT\Tutorial\Tutorial_10
Step 1 Selecting the Design Page
size
Click 1, then 2.
Select under Machine Type (3), and
then select Hoop Size (4) and choose a
Design Page size of 130 × 300 mm or 100 ×
172 mm from the selector (5). Then, click OK
(6).
a
b
c
a
b
c
ABC
Example of multi-position hoop: 100  172 mm hoop
Step 1 Selecting the Design Page size
Step 2 Creating the design
Step 3 Optimizing hoop changes
Step 4 Checking the pattern
1
1
2
2
3
6
5
4
le_specific.fm Page 161 Thursday, May 27, 2010 8:24 PM