Brother PE-Design Next - Advanced Operations for Entering Monograms; Editing Monograms

106
Advanced Operations for Entering Monograms
Advanced Operations for Entering
Monograms
Editing monograms
Monogram attributes can be selected from the
Attributes tab in the Ribbon, the Sewing
Attributes pane, the Text Attributes pane and the
Color pane. When the Monogram tool is selected,
the Attributes tab appears as shown below.
■ Monogram font
Click in the Font selector, and then click the desired
font.
(1) Font sample
If a single monogram is selected, the fonts
in the list appear with the selected
monogram characters.
(2) Most recently used fonts
(3) Monogram fonts
(4) Other fonts
The settings for all monogram attributes except the
font are specified in the same way that they are
specified for regular text patterns.
However, with monograms, settings cannot be
specified for the following.
• Rotate Angle, Character Spacing, Line Spacing,
Alignment, Direction
• Transform
• Name Drop
• Fit text to outline
b Memo:
The Attributes tab (under Text ) appears
when a monogram or the Monogram tool is
selected.
b Memo:
Diamond and Script are fonts exclusively for
monograms. You can also use built-in fonts,
custom fonts and TrueType fonts.
c
For a list of the built-in fonts and
monogram fonts, refer to “Font List” on
page 310.
(3)
(2)
(1)
(4)
XE8656-001.book Page 106 Monday, May 24, 2010 5:44 PM