Brother PE-Design Next - Creating Fill;Stamp Stitch Pattern

231
Programmable Stitch Creator
Creating Fill/Stamp Stitch Pattern
Creating Fill/Stamp Stitch Pattern
Existing programmable stitch patterns can be edited to create new patterns.
Step 1 Opening a fill/stamp stitch
pattern
First, we will open a fill/stamp stitch pattern to be
edited. In this example, we will use pattern
wave1.pas.
Click (Start), then select All Programs,
then PE-DESIGN NEXT, then Tools, then
Programmable Stitch Creator.
Click 1, then 2.
Select Fill/Stamp File(*.PAS) in the Files of
type selector.
Select the pattern file wave1.pas.
The pattern file can be found at the following
location.
For example, (Drive where PE-DESIGN was
installed)\Program Files (Program Files
(x86))\Brother\PE-DESIGN NEXT\Pattern.
Step 2 Drawing lines to edit the fill/
stamp stitch pattern
Click 1, then 2.
Step 1 Opening a fill/stamp stitch pattern
Step 2 Drawing lines to edit the fill/stamp stitch pattern
Step 3 Applying embossing/engraving effects to the fill/stamp stitch pattern
Step 4 Saving the edited fill/stamp stitch pattern
Step 5 Using the edited fill/stamp stitch patterns in Layout & Editing
1
2
1
2
3
b Memo:
To view the data in the selected folder as
thumbnails in the
Browse dialog box, click
Browse .
1
1
2
XE8656-001.book Page 231 Monday, May 24, 2010 5:44 PM