Brother PE-Design Next - Editing Entered Text; Setting Text Attributes

93
Creating Embroidery Patterns Containing Text
Advanced Operations for Entering Text
Editing entered text
1. Select a single text pattern.
2. Click 1, then 2.
Otherwise, click the Text Attributes tab (3),
and then click in the text field (4).
3. Edit the text as needed.
Press the key or click the Design
Page.
Setting text attributes
Text attributes can be specified with the Font
selector and Text Size selector in the Attribute tab.
■ Font
Click in the Font selector, and then click the desired
font.
(1) Font number
(2) Font sample
If a single string of text is selected, the
fonts in the list appear with the selected
characters.
(3) Types of characters available
c
Memo of “Font List” on page 313
(4) Most recently used fonts
(5) Built-in Fonts
(6) Custom Fonts
(7) TrueType Fonts
• Custom Fonts
c
“Font Creator” on page 245
b Memo:
The Attributes tab (under Text ) appears when
a text pattern or a Text tool is selected.
1
2
3
4
Enter
(1)
(2)
(4)
(3)
(5)
(6)
(7)
PEF files created with Font Creator
and saved in the MyFont folder where
PE-DESIGN was installed appear as
userdefined fonts after the fonts listed
in the table above.
The UD icon appears on custom
fonts.
XE8656-001.book Page 93 Monday, May 24, 2010 5:44 PM