Brother PE-Design Next - Page 234

232
Creating Fill/Stamp Stitch Pattern
Click points 1 through 4.
Double-click 5 (end point).
Repeat the previous operations.
Step 3 Applying embossing/engraving
effects to the fill/stamp stitch pattern
Click 1, and then double-click 2.
Next, click 3, and then double-click 4.
 Lines are drawn along the top and bottom
edges of the Design Page.
Click 1, then 2, and then click the first and
fourth wave regions.
 These regions appear in red and will be
sewn with short stitches to give the effect
of engraving.
b Memo:
• To remove the last point that was entered,
click the right mouse button.
c
“Reshaping a fill/stamp stitch
patterns” on page 235
• The grid width can be changed.
c
“Changing the grid settings” on
page 244
2
1
2
3
4
3
5
4
b Memo:
In order to create an effect, the lines must form
a closed region.
1
1
2
43
2
1
2
XE8656-001.book Page 232 Monday, May 24, 2010 5:44 PM