Brother PE-Design Next - Page 188

186
Basic Design Center Operations
After selecting the colors to be used for the
outlines, click OK.
 The line image appears in the Design
Page.
Step 2 Line Image Stage
■ Using the Eraser
To erase a line, select the Eraser Tools. Click
1, then 2.
Select an Eraser tool according to the size of
the area or thickness of the line to be erased.
Move the pointer over the line to be erased,
and then click the line or drag the pointer to
erase the line.
■ Using the Pen
To draw lines, select the Pen Tools. Click 1,
then 2.
Select the Pen tool with the desired thickness
of the line to be drawn.
Drag the pointer to draw a line. To add a point,
click in the Design Page.
6
1
1
2
2
b Memo:
To draw vertical or horizontal lines, hold down
the key while moving the pointer.
b Memo:
• If lines are drawn or erased incorrectly, click
(Undo button) ( 1 ) to undo the last
operation.
• To change the display size, use
Zoom
command (
2 ).
• The part of the work area that is displayed
can easily be changed by using the
Pan tool
(
3 ).
1
1
2
2
Shift
1
2
3
design.fm Page 186 Wednesday, May 26, 2010 7:12 PM