Brother PE-Design Next - Page 191

189
Design Center
Basic Design Center Operations
To change the shape of the line, drag the
point.
■ Splitting lines
Lines can be split at a point.
Perform steps and in “Reshaping
outlines” to select a line.
Select a point 1, and then click 2 to split the
line.
■ Connecting lines
Two points can be connected to form a line.
Perform steps and in “Reshaping
outlines” to select a line.
While holding down the key, drag the
selected point to the other point that you want
to connect to it.
 The shape of the pointer changes to ,
and a red square appears when the two
points are overlapping.
Release the mouse button to connect the two
points.
■ Continuing to the Sew Setting
Stage
When the figure handle image is finished, continue
to the Sew Setting Stage.
Click 1 or 2 .
b Memo:
• If multiple points are selected, all of the
points will be moved or deleted.
• To select additional points, hold down the
key and click each point, or drag the
pointer over the points.
5
Ctrl
1
1
2
2
2
1
1 1 2
2
Alt
3
1
1
2
XE8656-001.book Page 189 Monday, May 24, 2010 5:44 PM