195
Original Image Stage
Opening a file
1. Click 1, then 2.
2. Select the drive and the folder.
3. To open a file, select it, and then click Open,
or double-click the file's icon.
b Memo:
• To import an image from a file TWAIN
device
• Connect the TWAIN device to the
computer, and then click
Image
, then
Open from TWAIN Device
, or click
From TWAIN Device
in the
From
Image
dialog box. When the
Select
Source
dialog box appears, select a
device. Next, click
Select
.
• For information on using the driver
interface, refer to the help manual for
that interface, or contact the
manufacturer of the interface.
• Tips for scanning illustrations for Design
Center
• If the outline is not clear, trace the
outline on tracing paper.
• Better scanning results may be
produced by reducing the tone of the
image.
b Memo:
• If an image file is selected, the file is opened
in the Original Image Stage.
• If a .pel file is selected, the file is opened in
the Line Image Stage.
• If a .pem file is selected, the file is opened in
the Figure Handle Stage or the Sew Setting
Stage.
XE8656-001.book Page 195 Monday, May 24, 2010 5:44 PM
To Next Page
Loading...
