Brother PE-Design Next - Page 28

26
Tutorial 1: Getting Started
Move the pointer over a handle, and then,
while holding down the left mouse button, drag
the mouse to adjust the selected pattern to the
desired size.
To adjust the positions of the embroidery
patterns, click the pattern, and then position
the pointer over the pattern. When the shape
of the pointer changes to , hold down the
left mouse button and drag the pattern to the
desired location.
c
“Editing Embroidery Designs” on page 50
Step 4 Adding text and setting
character spacing
Click 1, then 2, then 3.
Click below the tulip in the Design Page.
 A vertical dashed line will appear on the
Design Page.
From the keyboard, type in “Tulip”.
Press the key.
 The text is entered.
Click the text to select it.
Click 1 in the Color tab to change the color of
the font.
b Memo:
• If a handle is dragged while the key
and the left mouse button are held down,
the pattern is enlarged or reduced from the
center of the pattern.
• The size of the embroidery pattern appears
in the status bar.
2
Shift
3
1
1
2
3
2
3
4
Enter
5
6
1
XE8656-001.book Page 26 Monday, May 24, 2010 5:44 PM