Brother PE-Design Next - Page 42

40
Drawing Shapes
■ //
: Arc
: Arc & String
: Fan
1. Proceed as you would to draw a circle or an
oval.
 A radial line appears on the oval when the
mouse button is released.
2. Move the pointer to the start point of the arc,
and then click.
 The radial line disappears.
3. Move the pointer until the arc/arc & string/fan
has the desired shape, and then click.
b Memo:
Rectangles with rounded corners
To change the radius of the corners, click the
Edge radius selector, located in the Outline
Attributes tab. Then type the desired radius
and press the key, or select the
desired value.
Enter
Example 1
Edge radius: 0.0 mm
Example 2
Edge radius: 20.0 mm
b Memo:
Dragging the pointer while holding down the
key moves it in 15° increments. The
current angle is shown in the status bar.
Shift
Arc
Click at start point.
Move to end point.
Click at end point.
Click at start point.
Arc & String
Move to end point.
Click at end point.
XE8656-001.book Page 40 Monday, May 24, 2010 5:44 PM