Brother PE-Design Next - Page 44

42
Drawing Shapes
1. First, select the Line/Region tool. Click 1, then
2, then 3.
: Click points to draw a closed line
constructed of straight lines.
(Shortcut key: )
: Click points to draw a closed curve.
(Shortcut key: )
: When a template image is displayed,
click along the outlines of the image to
draw closed lines tracing the image.
(Shortcut key: )
: Drag the pointer to draw a closed
freehand curve.
: Click points to draw an open line
constructed of straight lines.
(Shortcut key: )
: Click points to draw an open curve.
(Shortcut key: )
: When a template image is displayed,
click along the outlines of the image to
draw open lines tracing the image.
(Shortcut key: )
: Drag the pointer to draw an open
freehand curve.
2. Click in the Design Page or drag the pointer to
draw the line.
■ Straight lines/curves
1. Click in the Design Page to specify the start
point.
2. Click in the Design Page to specify the next
point.
b Memo:
• The shortcut keys are available only after a
Line/Region tool has been selected.
• When a Region tool is selected, pressing a
shortcut key switches to the corresponding
Region tool. When a Line tool is selected,
pressing a shortcut key switches to the
corresponding Line tool.
1
2
3
Z
X
C
Z
X
C
b Memo:
• To remove the last point that was entered,
click the right mouse button, or press the
key.
• The Curve tool and Semi-Automatic tool are
used in the same way.
BackSpace
XE8656-001.book Page 42 Monday, May 24, 2010 5:44 PM