Disassembly
When servicing starter motor, clean component
parts
thoroughly.
DO
NOT use a degreasing tank or grease dissolv-
ing solvent
on
yoke assembly, armature coil, over-
running clutch
assembly, magnetic switch, or rub-
ber or plastic parts. These parts should
be
cleaned with compressed air or wiped with a clean
cloth.
IMPORTANT: Before disassembling starter
motor, put match marks at three
locations (A,
B,
and C) to avoid any possible alignment mistakes.
004741
Remove nut from magnetic switch, then discon-
nect the connecting wire.
Remove two screws securing magnetic switch.
1.
Nut
004742
2. Connecting wire
3. Magnetic switch screws
ELECTRICAL
ELECTRIC STARTER SYSTEM
Remove the magnetic switch.
1. Magnetic switch
004743
Remove screws, long through bolts, and rear
cover.
1. Rear cover screws
004744
2.
Through bolts
3. Rear cov
er
Remove thrust washer with screwdriver.
1. Thrust
wa
s
her
0047
45
81
II
E
o
U
Qj
)(
~
Qj
~
ii
E
To Next Page
Loading...
