Operation
H172203_1_001 209 / 234
20 Operation
20.1 General Operating Guidelines
There are several general rules and procedures that should be observed while operating the
device.
Prior to the first use after installation, make sure that the BSMS system is properly
configured. Please refer to the chapters in this manual.
The only user operations permitted are:
• Starting up and shutting down the BSMS system.
• Operating the users software interface.
• Connecting signal and data interface cables that are accessible outside of the BSMS
system.
• Replacing or installing field replaceable units (by instructed operating or service personal).
Operator Protection
The electronic circuitry of BSMS system is operating with low and safe voltages, except for
the power supply and its connection to mains. Nevertheless, any electrical equipment can
become a source of danger under extreme conditions.
Temperature Changes
When the ambient temperature changes significantly (for example, after moving the device
from the stock room before mounting), wait at least 1 hour until the device has achieved room
temperature before turning on the device.
WARNING
Risk of injury from improper operation!
Improper operation can result in serious injury and significant damage to property.
u Carry out all operating steps in accordance with the specifications and instructions in
this manual.
u Before starting work, ensure that
- All covers and safety devices are installed and functioning properly.
- No persons are in the danger zone.
u Never disable or bypass safety devices during operation.
To Next Page
Loading...
General