Nitrogen Level Sensor
H172203_1_001 199 / 234
17.3 Service
This new digital nitrogen level sensor does not need any calibration in the field, the product is
factory calibrated.
17.3.1 Service Web
There is an ELCB Service Web page available for the nitrogen level measurement.
17.3.2 Diagnostic and Troubleshooting
The device state is displayed using the 5 LED. See Figure 17.3 [} 198] for detailed
description.
In addition, on-board diagnosis data or failure events are sent to the ELCB immediately and
displayed within TopSpin GUI or log file.
17.4 System Requirements
See Configuration [}195].
17.5 Ordering Information
Part numbers of the sensor depend on magnet size and height. Please consult your local
Bruker office.
To Next Page
Loading...