Transport, Packaging and Storage
24 / 234 H172203_1_001
Permitted Stacking Load Indicates packages which are partially
stackable.
Do not exceed the maximum load-bearing
capacity specified on the symbol in order to
avoid damaging or destroying the content.
Do not Damage Air-tight
Packaging
The packaging is air-tight. Damage to the
barrier layer may render the contents
unusable.
Do not pierce.
Do not use sharp objects to open.
Component Sensitive to
Electrostatic Discharge
The packaging contains components which
are sensitive to an electrostatic discharge.
Only allow packaging to be opened by trained
personnel.
Establish potential equalization before
opening.
Protect from Heat Protect packages against heat and direct
sunlight.
Protect from Radioactive
Sources
Protect packages against radioactive sources.
Table3.1: Symbols on the Packaging
3.2 Inspection at Delivery
Upon receipt, immediately inspect the delivery for completeness and transport damage.
Proceed as follows in the event of externally apparent transport damage:
• Do not accept the delivery, or only accept it subject to reservation.
• Note the extent of the damage on the transport documentation or the shipper's delivery
note.
• Initiate complaint procedures.
Issue a complaint in respect to each defect immediately following detection. Damage
compensation claims can only be asserted within the applicable complaint deadlines.
To Next Page
Loading...
General