Maintenance
H172203_1_001 211 / 234
21 Maintenance
The sections below describe the maintenance work required to ensure optimal and smooth
operation of the device.
If increased wear is found during regular checks, the required maintenance intervals should
be shortened in accordance with the actual wear occurrences. Contact Bruker in the event of
questions regarding maintenance work and intervals (see Contact [}221]).
Interval Maintenance Work Reference
Daily Clean the working area Laboratory SOP
As needed Clean Outer Shell of the Device
Update Firmware
Table21.1: Maintenance Schedule for Laboratory Personnel
21.1 Cleaning
21.1.1 Before Cleaning
1. Stop the device from doing any actions.
2. Switch the power off via PDU.
3. Switch the compressed gas supply off.
4. Disconnect the mains power cable.
21.1.2 Cleaning the Outside of the Cabinet Units
Do not use any detergent or other cleaning solvents. Use only water or neutral cleaning
fluids. Usage of volatile cleaners like thinner or benzine may damage the surface of the unit.
1. Clean the outside of the units with a soft, lint-free cloth dampened in water.
2. Wait until the unit is completely dry before you reconnect the power cable!
21.1.3 Cleaning the Outer Shell of the Device
Do not use any detergent or other cleaning solvents. Use only water or neutral cleaning
fluids. Usage of volatile cleaners like thinner, benzine or acetone may damage the surface of
the units.
• Do not disassembly the device for cleaning.
• Clean only the outer shell of the device with a lint-free cloth dampened in water.
To Next Page
Loading...
General