Operation
9
ekr CON 100 – Installation and Operating Manual 113/130
9.16 Displaying the CAN-Bus Status
This service display shows the CAN-Bus status.
Fig.54: Display of the CAN-Bus status
Pos. Name Status CAN-Bus status Meaning
① RUN
OFF stopped
The unit is in the initialisation phase.
No data transfer takes place.
FLASHING pre-operatnl.
The unit is in PREOPERATIONAL mode.
The initialisation process is complete.
The unit can be started.
ON operational The unit is in OPERATIONAL mode.
② ERR
OFF no error
The unit is functioning properly.
There is no error present.
ON error The interface controller is located in Bus-Off mode.
③ Id 11 Node number (device address of the controller)
Calling up the service display
1. Activate the service display CAN-Bus status in the setup menu
(see Calling up the Setup Menu, page 106).
The current CAN-Bus status is shown in the display.
2. Press the ENTER key to quit the service display.
The operation screen is displayed.
After a pre-set time (Timeout) has elapsed, the service
display is automatically quit. The operation screen is
displayed.
To Next Page
Loading...
Need help?
General
