BST ekr CON 100 User Manual

7
Electrical Connection
44/130 ekr CON 100 – Installation and Operating Manual
7.3 Connecting the Cables
Cables up to 0.34 mm
2
Use core end sleeves with collar for the connections (DIN 46228/
Part 4).
■ The crimping must be carried out gas tight (no cross-crimping).
■ There must be no gaps between the conductor and the core
end sleeve
■ The length of the metal sleeves fitted on the core end sleeve
must be at least 8 mm.
For crimping, we recommend the crimping pliers
VarioCrimp-4-Zange 206-204 from Wago.
Cables from 0.34 mm
2
to max. 0.5 mm
2
Connect the cables without core end sleeve.
■ For fine and multi-core cables and for fine-wired cables, whose
kink resistance is not sufficient due to the small diameter, in
order to overcome the contact force of the clamping springs,
the clamp must be properly opened using a screwdriver.
►
After connecting, in both cases check the correct fit of the cable.

BST ekr CON 100 Specifications

General

Brand	BST
Model	ekr CON 100
Category	Controller
Language	English