BST ekr CON 100 - Cleaning the Housing of the CLS Pro 600 Line and Contrast Sensor; Cleaning the Electric Motor Powered Actuator Housing

Maintenance and Cleaning
11
ekr CON 100 – Installation and Operating Manual 119/130
Cleaning the transmitting and receiving capsule (ultrasonic sensors)
►
Clean carefully using a dry, clean and soft cloth (e.g. glasses
wipe).
►
Use a commercially available liquid cleaner in event of intensive
soiling.
►
Perform the material setup after cleaning.
11.3.3 Cleaning the Housing of the CLS Pro 600 Line and Contrast Sensor
See separate operating instructions Line and contrast sensor
CLSPro600, EDP no. MD.323.
11.3.4 Cleaning the Electric Motor Powered Actuator Housing
The electric motor powered actuator is maintenance-free.
Cleaning the housing
The housing of the actuator must be cleaned if soiling can be seen
on the outside.
►
Clean using a dry, clean and soft cloth.
►
Use a commercially available liquid cleaner in event of intensive
soiling.