BST ekr CON 100 - X104 - Network

Electrical Connection
7
ekr CON 100 – Installation and Operating Manual 51/130
7.6.5 X104 - Network
The external control system (e.g. PLC, PC, machine control system,
etc.) is connected to the network interface of the controller via an
Ethernet network cable with an 8-pin RJ45 connector. The X104
socket is located behind the plastic plug (Network).
The network connection is currently not supported!
View of the socket from outside
Fig.18: Contact assignment of the network interface
Contact Function Note
1 TX+
2 TX-
3 RX+
4 Not used
5 Not used
6 RX-
7 Not used
8 Not used