6
Installation
38/130 ekr CON 100 – Installation and Operating Manual
6 Installation
6.1 Safety Instructions
WARNING
Danger of death and material damage caused by incorrect
installation!
►
Have the installation carried out only by qualified personnel
that have been instructed by BST service staff or authorized
personnel.
DANGER
Danger of death caused by the machine starting up!
Parts of your body could be crushed, cut, drawn in or hit.
►
Switch off the machine completely and secure it against it being
switched back on.
NOTICE
Damage to the system from drilling dust and loose parts!
Drilling dust, splitter and loose parts may damage the machine.
►
Before carrying out drilling or installation work, cover the
affected area of the machine with film or paper.
►
After installation work, check that the bolts are screwed tight.
Before starting with the installation work
►
Read the safety instructions in the operating instructions of the
machine in which the BST components are to be installed.
►
Observe the complete safety concept of the machine.
►
Cordon-off the work area in order to prevent access by unau-
thorized persons (e.g. by setting up barriers).
►
Make sure that all parts of the machine where the BST
components have to be installed have a sufficient load bearing
capacity.
During installation work
►
Observe all safety instructions and hazard warnings on the BST
components and the machine.
►
Do not deactivate or remove any protection and safety equip-
ment belonging to the machine. If the protection and safety
equipment has to be removed for the installation of the BST
components, these must be re-installed immediately after
completing the installation work.
►
Escape routes and access to safety equipment must not be
blocked by the installation of BST components.
►
Make sure that no parts (e.g. screws, washers, tools) can fall
into the machine. Cover the affected area of the machine with
film or paper. Parts falling down may damage the machine.
To Next Page
Loading...
Need help?
General
