Canon TX-4100 - Default Network Settings

Default Network Settings
LAN Connection Defaults
Item Default
Enable/Disable LAN Wired LAN enabled
Network name (SSID) BJNPSETUP
Communication mode Infrastructure
Wi-Fi security Disable
IP address (IPv4) DHCP
IP address (IPv6) Auto setup
Set printer name *1 XXXXXXXXXXXX
Enable/disable IPv6 Enable
Enable/disable WSD Disable
Timeout settings 15 minutes
Enable/disable Bonjour Enable
Service name Canon TX-NNNN *2
LPR protocol settings Enable
Wi-Fi DRX settings Enable
Wired LAN DRX settings Enable
("XX" represents alphanumeric characters.)
*1 Default value depends on printer. To check value, use operation panel.
LAN settings
*2 NNNN means your printer model name.
Wireless Direct Defaults
Item Default
Network name (SSID) DIRECT-abXX-TX-NNNN *1
Password YYYYYYYYYY *2
Wi-Fi security WPA2-PSK (AES)
Connection request confirmation Displayed
385