Canon TX-4100 - Page 390

Gigabit Ethernet Settings Communication speed and communication
method when using Gigabit Ethernet
Auto/10M half duplex/10M full du-
plex/100M half duplex/100M full du-
plex/1G full duplex
IP Address IPv4 IP address XXX.XXX.XXX.XXX
Gateway Address IPv4 default gateway XXX.XXX.XXX.XXX
Subnet Mask IPv4 subnet mask XXX.XXX.XXX.XXX
IP Mode Acquiring method of IPv4 IP address Auto IP/DHCP/Manual
Use DNS Auto Mode Acquiring DNS server automatically On/Off
Primary DNS Server Address Primary DNS server address XXX.XXX.XXX.XXX
Secondary DNS Server Address Secondary DNS server address XXX.XXX.XXX.XXX
Control Filtering SNMP filtering setting information -
Use IP Filtering Operation status of IP filtering On/Off
IP Filtering Select IP filtering method Disabled/Enabled
IP Filtering Permission Address IP filtering permission address -
Start Address 1 Start address 1 XXX.XXX.XXX.XXX
End Address 1 End address 1 XXX.XXX.XXX.XXX
Use Single On 1 Use single on 1 On/Off
Start Address 2 Start address 2 XXX.XXX.XXX.XXX
End Address 2 End address 2 XXX.XXX.XXX.XXX
Use Single On 2 Use single on 2 On/Off
Start Address 3 Start address 3 XXX.XXX.XXX.XXX
End Address 3 End address 3 XXX.XXX.XXX.XXX
Use Single On 3 Use single on 3 On/Off
Start Address 4 Start address 4 XXX.XXX.XXX.XXX
End Address 4 End address 4 XXX.XXX.XXX.XXX
Use Single On 4 Use single on 4 On/Off
Start Address 5 Start address 5 XXX.XXX.XXX.XXX
End Address 5 End address 5 XXX.XXX.XXX.XXX
Use Single On 5 Use single on 5 On/Off
IP Filtering Prohibit Address IP filtering prohibit address -
390