Cisco 7925G Administration Guide

Step 3
Click Save to make the change.
Wireless Security Credentials
When your network uses EAP-FAST, EAP-TLS, PEAP, or WPA2, CCKM for user authentication, you must
configure both the username and password if required on the Access Control Server (ACS) and the phone.
If you use domains within your network, you must enter the username with the domain name, in the format:
domain\username.
Note
Set Up Username and Password
To enter or change the username or password for the network profile, you must use the same username and
the same password string that are configured in the RADIUS server. The maximum length of the username
or password entry is 32 characters.
To set up the username and password in Wireless Security Credentials, follow these steps:
Procedure
Step 1
Choose the network profile.
Step 2
In the Username field, enter the network username for this profile.
Step 3
In the Password field, enter the network password string for this profile.
Step 4
Click Save to make the change.
Pre-Shared Key Setup
When using Auto (AKM) for WPA Pre-shared key or WPA2 Pre-shared key authentication, you must configure
a Passphrase/Pre-shared key in the Wireless Security Credentials area.
Pre-Shared Key Formats
The Cisco Unified Wireless IP Phone supports ASCII and hexadecimal formats. You must use one of these
formats when setting up a WPA Pre-shared key:
Hexadecimal
For hexadecimal keys, you enter 64 hex digits (0-9 and A-F); for example,
AB123456789CD01234567890EFAB123456789CD01234567890EF3456789C
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Administration Guide
83
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Web Pages
Wireless Security Credentials

Cisco 7925G Specifications

General

Keypad number of keys	12
Display diagonal	2 \
Display resolution	176 x 220 pixels
Call waiting	Yes
Lines quantity	6 lines
Voice codecs	G.711a, G.722, G.729a, iLBC
Security algorithms	128-bit WEP, SSL/TLS, WPA
Supported network protocols	DHCP, TFTP, DNS, SCCP, SRST
Input voltage	100 - 240 V
Dimensions (WxDxH)	52 x 20 x 127 mm
Minimum system requirements	Cisco Unified Communications Manager 4.1, 4.2, 4.3, 5.1, 6.0, 6.1, 7.0 + Cisco Unified Communications Manager Express 4.3 +
Input frequency	50/60 Hz
Storage temperature (T-T)	-30 - 60 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 95 %
Product type	IP Phone
Product color	Gray
Safety	UL 60950, CSA 22.2 No.60950, EN 60950, IEC 60950, AS/NZS 60950, IEC 60529 (IP 54)
Certification	47 CFR 15 B ICES-003 B EN 55022 B AS/NZS CISPR 22 B CISPR 22 B VCCI B EN 61000-3-2 EN 61000-3-3 KN 22 EN 55024 EN 50082-1 EN 61000-6-1 EN 300386 EN 60601-1-2 KN
Compliance industry standards	IEEE 802.11a, IEEE 802.11b, IEEE 802.11g, IEEE 802.1X, IEEE 802.11e

Weight and Dimensions

Weight	138 g